The correlations of the particle size, calorific value, moisture- and ash content of waste derived fuel, and examination of its heavy metal content

Authors

  • Csaba Leitol University of Pécs, Faculty of Engineering and Information Technology
  • Alexandra Győrfi University of Pécs, Faculty of Engineering and Information Technology
  • Tibor Kiss University of Pécs, Faculty of Engineering and Information Technology

DOI:

https://doi.org/10.14232/analecta.2020.1.109-117

Keywords:

mechanical-biological treatment, refuse derived fuel (RDF), particle size, calorific value, ash content, heavy metal content

Abstract

Significant development has taken place in the field of waste management recently in the preparation of the energetic exploitation of recyclable, non-hazardous municipal solid waste. With mechanical-biological waste treatment, 35-40% of the weight of this waste can be made appropriate for energetic exploitation, mainly for co-incineration in cement factories and power plants.

The recoverability of waste derived fuel produced in mechanical-biological waste treatment plants highly depends on the burning and combustion technological properties of the mixture, and on its compounds influencing burning and different emissions. Waste recovery facilities do not take over fuel below a specific calorific value and over a given heavy metal, halogen and pollutant content.

In our research we were looking for correlations in the particle size, calorific value, moisture-, ash- and heavy metal content of waste derived fuel. On the basis of the measurement results, the connection between the particle size fractions and the fuel properties can clearly be stated. The fractions of smaller particle size have higher moisture-, ash- and heavy metal content, while the fractions of bigger particle size have higher calorific value.

Downloads

Download data is not yet available.

References

Ecoprog, The Market for Mechanical Biological Waste Treatment in Europe (2017)

Országos Közszolgáltatási Hulladékgazdálkodási Terv (National Waste Management Public Service Plan), OKHT, National Coordination of Waste Management and Asset Management Plc (2017)

M. Kara, Environmental and economic advantages associated with the use of RDF in cement kilns, Resources, Conservation and Recycling, 68 (2012) pp. 21–28.

L. Zhaoet al., Characterization of Singapore RDF resources and analysis of their heating value. Sustainable Environment Research, 26 (2016) pp. 51-54.

M. Hasanbeigi et al., International Best Practices for Pre- Processing and Co-Processing Municipal Solid Waste and Sewage Sludge in the Cement Industry, Berkely National Laboratory, (2012)

M. Nasrullah, Material and energy balance of solid recovered fuel production, Aalto Universitychool of Chemical Technology doctoral dissertation, (2015)

C. A. Velis, Solid recovered fuel production through the mechanical-biological treatment of wastes, Cranfield University School of Applied Sciences, Ph.D Thesis (2010)

E. C. Rada et al., (2014) Selective collection as a pre-treatment for indirect solid recovered fuel generation Waste Management 34 (2014) pp. 291–297

S. Rocca et al., Characterisation of major component leaching and buffering capacity of RDF incineration and gasification bottom ash in relation to reuse or disposal scenarios, Waste Management, 32 (4) (2012), pp. 759-768.

O. Hjelmar et al., Incineration: solid residues, Solid Waste Technology & Management, 1 & 2 (2010), pp. 430-462.

M. C. Samolada et al., Energetic valorisation of SRF in dedicated plants and cement kilns and guidelines for application in Greece and Cyprus, Resources, Conservation and Recycling, 83 (2014) pp. 34–43.

Cs. Leitol et al., The correlations between the particle size, calorific value, moisture- and ash- content of waste derived fuel, III. Sustainable Raw Materials Conference Book – proceedings, Sopron, Hungary: University of Sopron, (2019) pp. 272-281.

M. Di Gianfilippo et al., LCA of management strategies for RDF incineration and gasification bottom ash based on experimental leaching data, Waste Management, 47 (B) (2016), pp. 285-298.

R. Baciocchi et al., Accelerated carbonation of different size fractions of bottom ash from RDF incineration, Waste Management, 30 (7) (2010), pp. 1310-1317.

K. Jagodzinska et al., The impact of additives on the retention of heavy metals in the bottom ash during RDF incineration, Energy, 183 (2019), pp. 854-868.

A. Győrfi et al., Experimental study of the correlation between the particle size and heavy metal content of waste derived fuel, III. Sustainable Raw Materials Conference Book – proceedings, Sopron, Hungary: University of Sopron, (2019) pp. 301-306.

V. Intrakamhaeng et al., Antimony mobility from E-waste plastic in simulated municipal solid waste landfills, Chemosphere, 241, (2020) 125042.

K. Ono, Past and future cadmium emissions from municipal solid-waste incinerators in Japan for the assessment of cadmium control policy, Journal of Hazardous Materials, 262 (2013), pp. 741– 747.

H. Zhang et al., Source Analysis of Heavy Metals and Arsenic in Organic Fractions of Municipal Solid Waste in a Mega-City (Shanghai), Environmental Science & Technology, 42 (2008), pp. 1586-1593.

Nagy S. et al., Experimental Study of the Further Development of MBT Products of High Calorific Value, Hulladék Online, (2012)

A. Győrfi et al., Study of the correlation between the particle size and the moisture content of waste derived fuel, II. Sustainable Raw Materials Conference Book - International Project Week and Scientific Conference, Szeged, Hungary: University of Szeged, (2019) pp. 154-159.

Cs. Leitol et al., Particle size analysis of waste derived fuel, the relation of individual particle size fractions and calorific value, II. Sustainable Raw Materials Conference Book - International Project Week and Scientific Conference, Szeged, Hungary: University of Szeged, (2019) pp. 160-167.

J. Faitli et al., Detailed Sampling Protocol for the Analysis of Residual Municipal Solid Wastes, Moustakas K., Loizidou M. (eds.) Proceedings of the 7th International Conference on Sustainable Solid Waste Management. Herakleion, Greek: Hellenic Mediterranean University, Session XXIII. (10) (2019) pp. 1-10.

A. Sarkady et al., RDF, Refuse Derived Fuel, Possibilities in the North-Balaton Regional waste management system, Pollack Periodica An International Journal for Engineering and Information Sciences, 9 (2014) pp. 23–30.

J. Faitli et al., Developing the combined magnetic, electric and air flow (KLME) separator for RMSW processing, Waste Management & Research, 36 (9) (2018) pp. 779-787.

Downloads

Published

2020-06-08

How to Cite

Leitol, C., Győrfi, A., & Kiss, T. (2020). The correlations of the particle size, calorific value, moisture- and ash content of waste derived fuel, and examination of its heavy metal content . Analecta Technica Szegedinensia, 14(1), 109–117. https://doi.org/10.14232/analecta.2020.1.109-117

Issue

Section

Articles